Food Truck Fire Suppression Systems Explained
What a food truck fire suppression system is, when you need one, what UL 300 means, how often it is serviced and what inspectors check.
A food truck fire suppression system is the automatic system built into your hood that puts out a grease fire on the cooking line and shuts off the fuel and power. If you fry or cook on a griddle, expect your fire department to ask for one. The official checklists we read ask for a wet chemical system that meets UL 300, serviced every six months.
Rules change; confirm with your local office.
This guide reflects the official checklists and pages we read in November 2026. It is general information, not legal advice. Your local fire department or fire marshal has the final word.
The short version
- Ask the fire department where you will sell whether your menu and equipment need a suppression system.
- If they do, ask which standard it must meet. Most checklists we read say UL 300.
- Use a contractor your fire department accepts for the installation.
- Get the system serviced and tagged every six months.
- Keep the service report, the system drawings and the manual on the truck.
- Show your crew where the manual pull station is and when to use it.
What is a food truck fire suppression system?
It is a fixed system with three jobs: detect a fire over the cooking line, spray an extinguishing agent on it, and cut the fuel and power to the appliances.
The Seattle Fire Marshal's Office publishes the checklist its inspectors use to accept a new wet chemical hood system in a building kitchen (revised September 30, 2025). It is not a food truck document, but it names the parts clearly:
- Agent tanks that hold the wet chemical, labeled UL 300.
- Nozzles aimed at each appliance, matching the system diagram, with nothing in the way of the spray.
- A fusible link or heat probe that triggers the system automatically.
- A manual actuator, often called a pull station, so a person can set it off.
- A control head with a visual indicator that shows whether the system is ready or needs recharging.
The South Carolina State Fire Marshal's policy on these systems (Policy 11-005, May 31, 2011) adds that wet chemical nozzles sit directly above each cooking surface and are typically covered with red, orange or yellow plastic caps or foil seals to keep them clean.
Does your food truck need a fire suppression system?
It depends on what you cook and where you sell. The common trigger in the official checklists is grease.
- NFPA. The National Fire Protection Association's Food Truck Safety fact sheet (October 2024) says appliances that produce grease-laden vapors should be protected by fire-extinguishing equipment.
- Maryland. The State Fire Marshal's Mobile Food Vehicle Checklist (December 2022) asks that grease-producing cooking equipment, hoods and plenums have a suppression system compliant with UL 300.
- Washington. The regional checklist from the Washington State Association of Fire Marshals (version dated February 12, 2026) asks for a UL 300 listed cooking suppression system under a Type I hood if the cooking produces grease-laden vapors.
- Albuquerque. The Albuquerque Fire Department's requirements for mobile food vendors say a Type 1 hood must be installed if the vendor produces any grease-laden vapors, with pan frying, deep-fat frying and griddle use given as examples, and that every Type 1 hood must have a pre-engineered suppression system.
- Austin. The Austin Fire Department says automatic hood suppression systems are mandatory for new mobile food vending units after May 1, 2022. Its list for units renewing a permit issued before that date names extinguishers and a propane report, and does not name a hood system.
Austin shows why you should ask before you buy. A used truck that passed in one city, or under an older permit, may not pass as a "new" unit somewhere else. Austin counts new construction, a change of ownership or a permit lapse of more than six months as new.
If you only serve items like coffee or ice cream, you may not need one at all. Austin, for example, does not require a fire permit for units with no propane and no cooking equipment. Your fire department decides.
What does UL 300 mean?
UL 300 is a fire test standard. South Carolina's policy describes it as the nationally accepted industry standard for "Fire Testing of Fire Extinguishing Systems for Protection of Commercial Cooking Equipment," and says all UL 300 compliant systems use a wet chemical extinguishing agent.
The same policy explains why the standard exists. Modern, better insulated cooking equipment and vegetable oils cook at much higher temperatures than older equipment and animal fats did. That makes hotter fires and makes a grease fire harder to control.
How to tell if a system meets UL 300
This matters most when you buy a used truck. South Carolina's policy gives two checks and one clue:
- Check with UL that the system's model number is listed as UL 300 compliant.
- Verify that all components were installed as the manufacturer's manual specifies.
- Look at the nozzles. Wet system nozzles are narrow, three-fourths of an inch to one inch across. Dry chemical nozzles, which the policy says are not compliant, are two inches across and may cover more than one appliance.
A look at the nozzles is only a clue. Ask a contractor your fire department accepts to confirm it in writing before you pay for the truck.
When an older system has to be upgraded
Rules for older systems are local. Two examples:
- Albuquerque's requirements say that when a pre-engineered dry chemical system cannot be installed or serviced annually, it must be upgraded to a UL 300 system.
- South Carolina's policy, for kitchens under the State Fire Marshal's authority, requires an upgrade of a non-UL 300 system when appliances are added or changed, when the hood is modified, when listed parts are no longer available for service, or when the cooking medium changes from animal fat to vegetable oil.
Changing your menu can change your fire protection. Washington's checklist asks that the cooking layout match the layout that was approved and inspected. If you add a fryer or move appliances, call your contractor and your fire department first.
How does the system work in a fire?
The system can start in two ways: on its own, when heat triggers the fusible link or heat probe, or by hand, when someone pulls the manual station.
Then, based on the Seattle acceptance checklist and the Maryland checklist:
- The agent discharges through the nozzles onto the appliances.
- Power and gas to the equipment under the hood shut off. Maryland asks that the system be interlocked with fuel and electric power.
- The control head shows that the system has operated.
- On a truck in Maryland, an audible and visual alarm on the outside of the vehicle is on the checklist as well.
The Seattle checklist notes that the control head shows when a system needs recharging. After any discharge, call your service contractor and your fire department before you cook again.
How often is a food truck fire suppression system serviced?
Every six months, in every official source we read that gives an interval:
- Maryland: semi-annual maintenance by an approved company.
- Washington: the checklist records the date of last service, marked "semiannually," and the date of last cleaning.
- Austin: a current semi-annual inspection tag.
- Albuquerque: serviced and inspected every 6 months.
Keep the tag current. Austin Fire lists expired service tags among its common reasons for a failed inspection.
What do inspectors check?
From the checklists named above:
- The system is UL 300 listed, serviced and tagged within the last six months.
- The manual pull station is in your escape path, easy to reach and not blocked (Maryland, Washington).
- The required signs are posted (Washington).
- The appliances under the hood match the approved layout (Washington).
- A Class K extinguisher is mounted nearby, with a placard that tells staff to activate the system first (Maryland, Washington).
- The paperwork is on the truck. Washington asks for the hood suppression system drawings and the inspection, test and cleaning reports from your contractor. Albuquerque asks for a current maintenance report from an authorized contractor, a manufacturer's certificate and a State Fire Marshal's Office certificate of fitness.
A new system may also need an acceptance test before your first permit. Albuquerque says new trucks or trailers with new hood suppression systems are inspected by its Plans Check Division, with an acceptance test of the system and the installing contractor's documents.
The suppression system is one part of the visit. For the rest, see our food truck fire inspection checklist.
How much does a food truck fire suppression system cost?
We did not find an official source for prices, so we do not print one. The cost depends on the size of your hood, how many appliances it covers and who installs it. Get written quotes from contractors your fire department accepts, and ask each one for the price of the six-month service too, because you will pay it twice a year.
Our guide to food truck startup costs shows where this fits in your budget.
Next steps
The suppression system is one item on the fire list, and the fire list is one layer of the stack. See the food truck fire inspection checklist for extinguishers, propane and generators, food truck permits for the licenses around it, and how to start a food truck for the full order of steps.
Once you pass, customers need to find you. Put your menu, photos and schedule on one page. Create my free page.
Sources
Official sources:
- South Carolina Office of State Fire Marshal: Policy 11-005, UL 300 Pre-Engineered Fixed Extinguishing Systems (PDF, May 31, 2011). Read November 20, 2026. It applies where that office has authority and is not specific to food trucks.
- Maryland State Fire Marshal: Mobile Food Vehicle Checklist (PDF, December 2022, references the 2021 edition of NFPA 1, Chapter 50). Read November 20, 2026.
- Washington State Association of Fire Marshals, hosted by the Washington State Building Code Council: Food Truck Inspection Checklist, 2021 IFC (PDF, version dated February 12, 2026). Read November 20, 2026.
- City of Austin, Austin Fire Department: Mobile Food Vending Fire Inspections. Read November 20, 2026. A local example, not a state rule.
- City of Albuquerque, Albuquerque Fire Department: General Requirements for Mobile Food Vendors (PDF, undated). Read November 20, 2026. A local example, not a state rule.
- City of Seattle, Seattle Fire Marshal's Office: Wet Chemical Kitchen Hood Suppression System Inspection Checklist (PDF, revised September 30, 2025). Read November 20, 2026. An inspector checklist for kitchens in buildings, used here only to name the parts of a system and how it is tested.
Standards body (not a government source):
- National Fire Protection Association: Food Truck Safety fact sheet (October 2024), read in the copy hosted by the West Virginia State Fire Marshal. Read November 20, 2026. The fact sheet says it is not a comprehensive list of requirements and tells readers to check with the local jurisdiction.
Frequently asked questions
- Does every food truck need a fire suppression system?
- No. The official checklists we read tie it to cooking that produces grease or grease-laden vapors, such as frying and griddle cooking. Whether your truck needs one is decided by the fire department where you sell, and the answer can differ for new trucks and permit renewals. Ask before you buy or build.
- What does UL 300 mean?
- UL 300 is a fire test standard for extinguishing systems that protect commercial cooking equipment. The South Carolina State Fire Marshal's policy says all UL 300 compliant systems use a wet chemical agent. Several food truck checklists, including Maryland's and Washington's, ask for a UL 300 system.
- How often does a food truck fire suppression system need service?
- Every six months in each official source we read that gives an interval: the Maryland State Fire Marshal checklist, Washington's regional checklist, the Austin Fire Department and the Albuquerque Fire Department. Keep the current service tag and the contractor's report on the truck.
- Do I still need a Class K extinguisher if I have a suppression system?
- Usually yes. The checklists ask for both. The South Carolina State Fire Marshal's policy calls the Class K extinguisher a secondary device, used after the hood system operates. Maryland and Washington ask for a placard next to it that tells staff to activate the system first.
- Can I install a fire suppression system myself?
- The official sources we read point to trained, approved or licensed contractors for installation and service, and some fire departments ask for the contractor's paperwork. Albuquerque, for example, asks for the installing contractor's documents and an acceptance test. Ask your fire department who is allowed to do the work in your area.